Page 1 of 1
606 belt issue?
Posted: Thu Feb 14, 2019 6:14 pm
by Robin
Please see picture below.
I had a new SS belt put on. It’s the correct belt but now I have an issue ( I think) with the alignment of the flex intake tube. It heads off at an angle. I do not remember it doing so before the install. Is it ok or do I need to do something like a longer belt.
Thanks,
Robin
Re: 606 belt issue?
Posted: Fri Feb 15, 2019 8:12 am
by BIGJOHN
Can you adjust the part coming up from the air cleaner?
Re: 606 belt issue?
Posted: Fri Feb 15, 2019 9:43 pm
by Robin
I do not think so. The air cleaner exc. is screwed onto place.
Robin
Re: 606 belt issue?
Posted: Sat Feb 16, 2019 2:55 pm
by BIGJOHN
In your photo the Honker intake looks off Center to your throttle body.
Re: 606 belt issue?
Posted: Sun Feb 17, 2019 12:10 am
by Bmakaz
I have seen a few pictures online of a slight angle from the air cleaner to the throttle body. If anything I would make sure you have a good seal on all the connectors so you are not sucking in dirty/unfiltered air into the engine.
Re: 606 belt issue?
Posted: Sun Feb 17, 2019 11:14 am
by Callaway Chris
The Honker was centered to the shroud, but the supercharger snout (due to the jackshaft) puts the inlet to the SC slightly off center. As such, there is a slight "kick" in symmetry of the bellow. Looks normal to me,
Re: 606 belt issue?
Posted: Sat Feb 23, 2019 2:47 pm
by BIGJOHN
It looks like my Honker is a little off Center also.
Re: 606 belt issue?
Posted: Sun Feb 24, 2019 8:31 pm
by Robin
Chris,
Are you saying mine is within your standards and don’t worry about it?
Thanks,
Robin