1987-1991 B2K Intake and valve cover refurbishment process outlined:
Posted: Fri Jan 10, 2020 1:06 pm
The question was recently asked, "Are the black parts of the intake a powder coat or painted finish?"
The answer is, they are painted. Here's the process.
Using VHT Wrinkle Plus Paint (P/N SP201) pre-heat the parts in an oven to 125* F.
Paint three (3) fairly heavy coats, with 5 minute between coats of paint.
Raise the oven temperature to 180* F to cure.
Overall, check each time every coat out every 15 minutes, leave in for a max for 30 min. Then let cool overnight.
Remove all rubber and plastic parts prior to this refurbishment process.
The answer is, they are painted. Here's the process.
Using VHT Wrinkle Plus Paint (P/N SP201) pre-heat the parts in an oven to 125* F.
Paint three (3) fairly heavy coats, with 5 minute between coats of paint.
Raise the oven temperature to 180* F to cure.
Overall, check each time every coat out every 15 minutes, leave in for a max for 30 min. Then let cool overnight.
Remove all rubber and plastic parts prior to this refurbishment process.